Changes between Version 26 and Version 27 of Documentation/CGettingStarted


Ignore:
Timestamp:
Feb 15, 2006, 5:42:39 PM (19 years ago)
Author:
Surya Satyavolu
Comment:

Legend:

Unmodified
Added
Removed
Modified
  • Documentation/CGettingStarted

    v26 v27  
    3636
    3737When you have successfully logged in, you can start an experiment using the [wiki:NodeHandler nodehandler]. First time users are '''highly''' encouraged to reserve time on a sandbox instead of the main grid, and start with the built-in ''Hello World'' experiment.
    38 * Prior to the experiment, users need to install the baseline image on the hard disks of the nodes. This process will soon be done by the system before a slot is approved so that users can directly start the experiment with their preferred image on the nodes
     38 * Prior to the experiment, users need to install the baseline image on the hard disks of the nodes. This process will soon be done by the system before a slot is approved so that users can directly start the experiment with their preferred image on the nodes
    3939
    4040[[Image(howto2.PNG)]]
     
    5252[[Image(howto4.PNG)]]
    5353
    54 This experiment will send UDP datagrams of 1024 bytes from node 1-1 to node 1-2 at 300 kbps CBR traffic. Both, sender and receiver, report measurements to a database, using our [wiki:OML OML] measurement framework.
     54 * This experiment will send UDP datagrams of 1024 bytes from node 1-1 to node 1-2 at 300 kbps CBR traffic.
     55 * Both, sender and receiver, report measurements to a database, using our [wiki:OML OML] measurement framework.
     56 * As shown below, the experiment controller will power on the nodes involved in the experiment and will issue experiment commands to each node.
     57 * Each experiment has a unique experiment ID as shown in the figure, that can be used later to view the results from the database
    5558[[Image(howto5.PNG)]]
    5659