Changes between Version 6 and Version 7 of Hardware/dInfrastructure/qPowerMeasurment

Timestamp:

Aug 20, 2013, 9:26:44 PM (11 years ago)

Author:

pavan717

Comment:

—

Hardware/dInfrastructure/qPowerMeasurment

@@ -15 +15 @@
        - Ruby (Will be needed to parse XML output) [[BR]]
 '''Overall Operation:''' 
-   || [[Image (overview1.PNG, 400px)]] ||
-   || Figure 1: Full View ||
+
+|| [[Image(Overview1.PNG, 600px)]] ||
+||  Figure 1: Full View ||
+[[BR]] 
+1) Total of 4 nodes are connected to one outlet.[[BR]] 
+2) 2-3 Outlets are connected to a single breaker switch.[[BR]] 
+3) On the breaker board behind each breaker switch there is a toroid.[[BR]] 
+4) A Brultech Micro-40 Donut Style toroid is used to scale down the current at a ratio of 40A to 26.23mA.[[BR]] 
+5) The ends of the toroid sensors are connected to the ORBIT Power Sensing Platform.[[BR]] 
+6) The ORBIT Power Sensing Platform is connected to the Arduino board and shield.[[BR]]  
+
+'''Power Sensing Platform:'''
+ 
+
+  
+
 [[BR]]
 
 '''Procedure:''' 
    1: Connect the Arduino Board and Arduino Ethernet Shield to the ORBIT Power Sensing Platform. The Arduino board will be connected to the bottom of the ORBIT Power Sensing Platform and the Arduino Ethernet Shield will be place on the top of the ORBIT Power Sensing Platform as shown below:
-      
- || [[Image(board.PNG, 400px)]] ||
- ||  Figure 2: Connection  || 
+
+|| [[Image(board.PNG, 400px)]] ||
+||  Figure 2: Connection  || 
   
 [[BR]]