Changes between Version 13 and Version 14 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

Timestamp:

Aug 24, 2011, 9:42:12 PM (13 years ago)

Author:

ssugrim

Comment:

—

Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

@@ -4 +4 @@
 The assembling of new LV-67C based orbit node can be broken down into 3 tasks.
 
- 1. [#Lv67cBios Flash The LV67-C bios '''UPDATED''']
+ 1. [#Lv67cBios Flash The LV67-C bios] '''UPDATED'''
  1. [#Cm3Install flash and install the CM3 module]
  1. [#CaseAssembly Install Motherboard / Power supply]
@@ -44 +44 @@
  1. Once powered off, remove the video card and attach the nic card (if needed). Connect the ethernet cable that carries Outdoor control vlan to the designated eth1 interface. 
  1. Power on the node and hit del again to get back into the bios.
- 1. In the boot menu choose the IBA GE slot 0100 v1321 boot item and exclude it from the boot sequence.
+ 1. If making a USRP node, in the boot menu choose the IBA GE slot 0100 v1321 boot item and exclude it from the boot sequence.
  1. Depending on node type you will see an item labeled IBA GE slot xxxx v1324. Where xxxx is the hex address for the device (e.g. 0900 for Lan 1). Set this device to be !#1 in the boot sequence. Save and exit.
  1. The node should now attempt to boot from pxe and if dhcp and tftp are setup correctly, the node should be able to boot into the pxe image.