Changes between Version 14 and Version 15 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

Timestamp:

Aug 25, 2011, 4:05:52 PM (13 years ago)

Author:

ssugrim

Comment:

—

Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

@@ -165 +165 @@
    1. The drive should be on the "inside" of the chassis and sata header should point to the left (towards the center of the case).
   1. Fasten the disk, stand off assembly to the face plate with the M3 5mm pan head screws. 
-  1. Attach power and sata cables to the drive. 
-   1.When attaching the sata cable to the mother board, use the header closest to the CPU (sata1)
+  1. Attach power and sata cables to the drive.
+   1. When attaching the sata cable to the mother board, use the header closest to the CPU (sata1)
  1. loop the velcro strap through the holes on the bottom:
   1. Tie down all the loose wires. 
-  1.This prevents stray wires from getting to close to the cpu fan.
+  1. This prevents stray wires from getting to close to the cpu fan.
  1. Mount the rear face plate:
   1. Use the three 6-32 1/4" 100 degree screws to attach the front face.