Changes between Version 17 and Version 18 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

Timestamp:

Aug 30, 2011, 8:14:30 PM (13 years ago)

Author:

Ilya Chigirev

Comment:

—

Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

@@ -146 +146 @@
   1. place the cable in the cut out on the top of the face plate opening.
   1.  Attach the mother board face plate to the opening on the rear face plate cap, locking the serial cable into the designated opening.
-   1. The face plate should be mount so that it is open on the right side (to allow for a expansion card) and closed on the left (as close to the power supply opening as possible).  
+   1. The face plate should be mount so that it is open on the right side (to allow for a expansion card) and closed on the left (as close to the power supply opening as possible). Install the end of the serial cable that is later attached to the CM at this time as well, as it gets threaded through the faceplate. 
  1. Mounting the rear cap on the U channel Chassis:[[BR]][[Image(FrontFace.jpg, 300)]]
   1. Fasten the rear cap  with 2 of the 6-32 1/4" 100 degree screws on the bottom of the U chassis. 
@@ -155 +155 @@
    1. Header 2 immediately to the right of header 1. 
    1. !WiFi header of the 802.11 card goes to the right most hole. 
+ 1. Wiring the CM:
+  1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300)]]. 
+  1. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. 
  1. Mounting the CM:[[BR]][[Image(CmMount.jpg, 300)]]
-  1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws
+  1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
   1. thread the other end of the serial cable between the 3 stand offs
   1. align the 3 stand offs with the 3 triangle oriented holes on the front left corner of the top of the U chassis. 
-  1. use the 3 3/16" 100 degree screws to attach the cm to the U chassis
- 1. Wiring the CM:[[BR]][[Image(CmWire.jpg, 300)]][[Image(CmWireMotherB.jpg, 300)]][[Image(VampClip.jpg, 300)]]
-  1. '''ILYA FIX ME'''
+  1. thread the other end of the flat serial cable (otherside should be going through slit on top of the face plate) in between the standoffs as to keep it in place and above the fan, them use the 3 3/16" 100 degree screws to attach the cm to the U chassis.
  1. Attach and Wire the hard drive:[[BR]][[Image(DiskStandOff.jpg, 300)]][[Image(DiskBackPlate.jpg, 300)]][[Image(DiskWire.jpg, 300)]]
   1. attach the M3 5mm hex stand offs to the hard dive using the bottom holes.