Changes between Version 37 and Version 38 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C


Ignore:
Timestamp:
Sep 20, 2012, 3:21:11 PM (12 years ago)
Author:
Ilya Chigirev
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

    v37 v38  
    8181   1. Header 2 immediately to the right of header 1.
    8282   1. !WiFi header of the 802.11 card goes to the right most hole.
    83  1. Wiring the CM:
    84   1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300)]].
    85   1. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]][[Image(CmWire.jpg, 300)]]
    86 
    87  1. Mounting the CM:[[BR]][[Image(CmMount.jpg, 300)]]
    88   1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
    89   1. thread the other end of the serial cable between the 3 stand offs
    90   1. align the 3 stand offs with the 3 triangle oriented holes on the front left corner of the top of the U chassis.
    91   1. thread the other end of the flat serial cable (otherside should be going through slit on top of the face plate) in between the standoffs as to keep it in place and above the fan, them use the 3 3/16" 100 degree screws to attach the cm to the U chassis.
     83 1. Install the CM as directed by [http://www.orbit-lab.org/wiki/Hardware/fAssembly/CM here].
    9284 1. Attach and Wire the hard drive:[[BR]][[Image(DiskStandOff.jpg, 300)]][[Image(DiskBackPlate.jpg, 300)]][[Image(DiskWire.jpg, 300)]]
    9385  1. attach the M3 5mm hex stand offs to the hard dive using the bottom holes.
    … …  
    9688   1. The drive should be on the "inside" of the chassis and sata header should point to the left (towards the center of the case).
    9789  1. Fasten the disk, stand off assembly to the face plate with the M3 5mm pan head screws.
    98   1. Attach power and sata cables to the drive.
    99    1. When attaching the sata cable to the mother board, use the header closest to the CPU (sata1)
    100  1. loop the velcro strap through the holes on the bottom:
     90  1. Attach power and SATA cables to the drive.
     91   1. When attaching the SATA cable to the mother board, use the header closest to the CPU (sata1)
     92 1. loop the Velcro strap through the holes on the bottom:
    10193  1. Tie down all the loose wires.
    10294  1. This prevents stray wires from getting to close to the cpu fan.