Changes between Version 10 and Version 11 of Hardware/hNodes/cNodeVer5

Timestamp:

Feb 14, 2017, 8:41:49 PM (8 years ago)

Author:

jkol

Comment:

—

Hardware/hNodes/cNodeVer5

@@ -66 +66 @@
   The NUC6i5SYK's front panel header is located on the "back side" of the board (opposite side of where the SSD is installed). Other NUC's may have this header located elsewhere.
 
-Internal wiring
+Assembly:
+  1. Remove the NUC case bottom plate (it will not be used)
+  2. Remove motherboard (if necessary) and connect cables that will go to the CM3
+  3. Reinstall motherboard
+  4. Install standoffs (2x20mm per corner) in the four corners where the case bottom screws would go
+  5. Install SSD and RAM
+  6. Connect SMA cables to USRP before installing in case extension
+  7. Install USRP in case extension
+  8. Install the SMA cable between the USRP's 10MHz/PPS reference port and the rear of the case extension
+  9. Install CM3 in case extension
+  10. Install CM3 and connect the cables between it and the NUC
+  11. Install the SMA cables between the TX/RX, RX2 ports on the USRP and the case extension sides
+  12. Put the NUC and case extension together using the M2.5 screws
+  13. Attach the USB 3.0 cable between the NUC and USRP
+  14. Add rubber feet to the case extension bottom if desired