Changes between Version 3 and Version 4 of Hardware/jCM/cCM2/aHardware/RiserCard

Timestamp:

Oct 1, 2008, 2:47:37 AM (16 years ago)

Author:

seskar

Comment:

—

Hardware/jCM/cCM2/aHardware/RiserCard

@@ -9 +9 @@
 == Standby voltage feed ==
 
- [[Image(Clip.jpg, 160px, right)]]  CM2 stand-by voltage is provided with the separate wire that is attached directly to the +5VSB wire of the ATX power supply with the self-tapping connector (MOLEX [http://delta.octopart.com/Molex__19216-0005.pdf Multi-Lock Insulation Displacement Connector (IDC)] ) show on figure 2. 
+[[Image(Clip.jpg, 160px, left)]] CM2 stand-by voltage is provided with the separate wire that is attached directly to the +5VSB wire of the ATX power supply with the self-tapping connector (MOLEX [http://delta.octopart.com/Molex__19216-0005.pdf Multi-Lock Insulation Displacement Connector (IDC)] ) show on figure 2. 
 
-The purple wire on the ATX power supply connector is fed through the slit opening on the IDC while the red wire from the riser card is fed into the second hole on the clip and the taping header is gently squeezed into position and locked with the cover.
+The purple wire on the ATX power supply connector is fed through the slit opening on the IDC while the red wire from the riser card is fed into the second hole on the clip and the taping header is gently squeezed into position and locked with the cover [[Image(ATX20-Male.png, right)]]
+
 
 {{{
@@ -42 +43 @@
 }}}
 
+
 == Installation ==