| Version 8 (modified by , 14 years ago) ( diff ) |
|---|
Software Description
Requirements of Software
- HTML node control
- Turn on and off node via HTML address
- UDP control
- connect to CMC
- periodically send status packets
- self registration
- commands issued and responded to over UDP
- Watchdog timer
- update over HTML command
I2C protocol
The lantronix Xport AR does not come with a native I2C bus to the I2C communication between the node ID box and the hardware monitor chip (DS1780E) must be accomplished through bit-banging. The configuration of the CM is that of one master and two slaves (NodeID box and DS1780E).
Attachments (2)
- serial_recovery.jpg (74.8 KB ) - added by 13 years ago.
-
REV_4_2_0.rom.gz
(594.2 KB
) - added by 12 years ago.
CM3 firmware V4.1.0
Download all attachments as: .zip
Note:
See TracWiki
for help on using the wiki.
