== Steps for setting up the WiMAX BTS on ORBIT ==

Please note: Do not restart BTS until all changes are complete. If you do happen to restart, you will have to use the serial interface to connect to the BTS.

* Change the IP address and correct configuration on the RF card.
  - Login to the BTS as root on 192.168.1.10/24
  - Copy the attached [WiMAX/BTSSetup/networkenv.orbit networkenv.orbit] file to /flash/networkenv
  - Use wiset commands below to correct configuration on the BTS:
  {{{
wiset authgw_id 0x41534E47
wiset authgw_port 0x08B7
wiset asngw_id 0x41534E4757303030
wiset asngw_dp_port  0x08B7
wiset asngw_ep_port 0x08B7
wiset bs_rx_port 0x08B7
wiset bsid 0x303030303030
wiset frequency  2551500
wiset bs_tx_power 40
wiset bw_mode 0
wiset dlul_ratio 2
wiset ttg 296
wiset rtg 168
wiset framesync_mode 2
wiset antenna_gain 0

# Other wiset commands changed to appropriately reflect new IP settings.
wiset authgw_ip 0x0A030047
wiset asngw_dp_ip 0x0A030047
wiset asngw_ep_ip 0x0A030047

  }}}

* Change settings on the N/W card.
  - Login to the N/W card at 192.168.1.42/24 again as root, and change the IP configuration for eth1 in the /etc/network/interfaces file as :
{{{
auto eth1
 iface eth1 inet static
     address 10.3.0.51
     network 10.3.0.0
     netmask 255.255.0.0
     broadcast 10.3.255.255
     gateway 10.3.0.1       
}}}