Steps for setting up the WiMAX BTS on ORBIT

Please note: Do not restart BTS until all changes are complete. If you do happen to restart, you will have to use the serial interface to connect to the BTS.

• Change the IP address and correct configuration on the RF card.
  • Login to the BTS as root on 192.168.1.10/24
  • Copy the attached networkenv.orbit​ file to /flash/networkenv
  • Use wiset commands below to correct configuration on the BTS:

    wiset authgw_id 0x41534E47
    wiset authgw_port 0x08B7
    wiset asngw_id 0x41534E4757303030
    wiset asngw_dp_port  0x08B7
    wiset asngw_ep_port 0x08B7
    wiset bs_rx_port 0x08B7
    wiset bsid 0x303030303030
    wiset frequency  2551500
    wiset bs_tx_power 40
    wiset bw_mode 0
    wiset dlul_ratio 2
    wiset ttg 296
    wiset rtg 168
    wiset framesync_mode 2
    wiset antenna_gain 0
    
    # Other wiset commands changed to appropriately reflect new IP settings.
    wiset authgw_ip 0x0A030047
    wiset asngw_dp_ip 0x0A030047
    wiset asngw_ep_ip 0x0A030047
    
    

• Change settings on the N/W card.
  • Login to the N/W card at 192.168.1.42/24 again as root, and change the IP configuration for eth1 in the /etc/network/interfaces file as :

    auto eth1
     iface eth1 inet static
         address 10.3.0.51
         network 10.3.0.0
         netmask 255.255.0.0
         broadcast 10.3.255.255
         gateway 10.3.0.1