== !AmariSoft LTE ==

[[Include(Documentation/Short/Prereq)]]

The image used for this experiment is 'baseline.ndz'. In this tutorial we will use nodes equipped with Netgear AC341u LTE dongles. The basestation is Amarisoft running on Bsc03out.

You will run the following commands on node7-1.grid.orbit-lab.org
After connecting to the grid console:
1. {{{ omf load -i baseline.ndz -t node7-1.grid.orbit-lab.org }}}
1. {{{ ssh root@node7-1.grid.orbit-lab.org }}}
1. {{{ modprobe GobiSerial }}}
1. {{{ modprobe GobiNet }}}
1. {{{ minicom -D /dev/ttyUSB1 }}}
1. {{{ AT!ippassthrough? }}}
 1. It should return 1
 1. If it does not, run {{{ AT!ippassthrough=1 }}} then {{{ AT!reset }}}
1. {{{ AT!entercnd="A710" }}}
 1. You should see {{{ OK }}}
1. {{{ AT!dxcfg=wwan,connect,11 }}}
 1. You should see {{{ OK }}} then {{{ $QCRMCALL: 1, V4 }}}
1. {{{ at!gstatus? }}}
 1. Will return a status like: 
{{{
at!gstatus?                                                                                                         
!GSTATUS: 
Current Time:  10049            Temperature: 42
Bootup Time:   0                Mode:        ONLINE         
System mode:   LTE              PS state:    Attached     
LTE band:      B25              LTE bw:      10 MHz  
LTE Rx chan:   8365             LTE Tx chan: 26365
EMM state:     Registered       Normal Service 
RRC state:     RRC Connected  
IMS reg state: No Srv  

RSSI (dBm):    -83              Tx Power:    0
RSRP (dBm):    -117             TAC:         0001 (1)
RSRQ (dB):     -10              Cell ID:     01A2D001 (27447297)
SINR (dB):      1.6
}}}
1. Exit Minicom by pressing Ctrl+A and then x, then enter to select ok.
1. Run {{{ dhcpcd eth2 }}} and the enter to get a new line.
 1. You should get an address in the 192.168.3.0/24 subnet.
1. {{{ Ping 192.168.3.1 }}}
 1. You have successfully communicated with the basestation.
1. {{{iperf -c 192.168.3.1 }}}
 1. This will report your bandwidth to the basestation.