Changes between Version 9 and Version 10 of Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM

Timestamp:

Sep 20, 2012, 3:23:08 PM (12 years ago)

Author:

Ilya Chigirev

Comment:

—

Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM

@@ -1 @@
- 1. Wiring the CM:
+==== Wiring the CM ====
   1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300)]]. 
   2. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]][[Image(CmWire.jpg, 300)]] [[Image(CmWireMotherB.jpg, 300)]]
 
- 1. Mounting the CM:[[BR]][[Image(CmMount.jpg, 300)]]
+==== Mounting the CM ==== 
+[[BR]][[Image(CmMount.jpg, 300)]]
   1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
   2. thread the other end of the serial cable between the 3 stand offs