Changes between Version 23 and Version 24 of Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM


Ignore:
Timestamp:
Jan 10, 2013, 11:33:28 PM (12 years ago)
Author:
Ilya Chigirev
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM

    v23 v24  
    22===== CM Installation =====
    33''' Wiring '''
    4   1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300, align=center)]].
     4  1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300]].
    55  2. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]][[Image(CmWire.jpg, 300)]] [[Image(CmWireMotherB.jpg, 300)]]
    66
    77''' Mounting ''
    8 [[BR]][[Image(CmMount.jpg, 300, align=center)]]
     8[[BR]][[Image(CmMount.jpg, 300)]]
    99  1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
    1010  2. thread the other end of the serial cable between the 3 stand offs